[PATCH 1/1] Documentation: Fix historical inconsistency in STMPE DT doc

[Lee Jones]

Previously a generic binding 'i2c-client-wake' was created which
enabled I2C devices to register themselves as wake-up devices.
This binding was later over-thrown by 'wakeup-source'. The STMPE
driver was fixed-up, but the document was neglected. This patch
aims to rectify that.

Cc: Samuel Ortiz <sameo at linux.intel.com>
Cc: devicetree-discuss at lists.ozlabs.org
Signed-off-by: Lee Jones <lee.jones at linaro.org>
---
 Documentation/devicetree/bindings/mfd/stmpe.txt |    4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/mfd/stmpe.txt b/Documentation/devicetree/bindings/mfd/stmpe.txt
index 8f0aeda..c984508 100644
--- a/Documentation/devicetree/bindings/mfd/stmpe.txt
+++ b/Documentation/devicetree/bindings/mfd/stmpe.txt
@@ -8,7 +8,7 @@ Optional properties:
  - interrupts                   : The interrupt outputs from the controller
  - interrupt-controller         : Marks the device node as an interrupt controller
  - interrupt-parent             : Specifies which IRQ controller we're connected to
- - i2c-client-wake              : Marks the input device as wakable
+ - wakeup-source                : Marks the input device as wakable
  - st,autosleep-timeout         : Valid entries (ms); 4, 16, 32, 64, 128, 256, 512 and 1024
 
 Example:
@@ -20,6 +20,6 @@ Example:
 		interrupt-parent = <&gpio6>;
 		interrupt-controller;
 
-		i2c-client-wake;
+		wakeup-source;
 		st,autosleep-timeout = <1024>;
 	};
-- 
1.7.9.5