[PATCH v2 3.7.0-rc4] of/net/mdio-gpio: Fix pdev->id issue when using devicetrees.
Srinivas KANDAGATLA
srinivas.kandagatla at st.com
Fri Nov 16 21:33:59 EST 2012
From: Srinivas Kandagatla <srinivas.kandagatla at st.com>
When the mdio-gpio driver is probed via device trees, the platform
device id is set as -1, However the pdev->id is re-used as bus-id for
while creating mdio gpio bus.
So
For device tree case the mdio-gpio bus name appears as "gpio-ffffffff"
where as
for non-device tree case the bus name appears as "gpio-<bus-num>"
Which means the bus_id is fixed in device tree case, so we can't have
two mdio gpio buses via device trees. Assigning a logical bus number
via device tree solves the problem and the bus name is much consistent
with non-device tree bus name.
Without this patch
1. we can't support two mdio-gpio buses via device trees.
2. we should always pass gpio-ffffffff as bus name to phy_connect, very
different to non-device tree bus name.
So, setting up the bus_id via aliases from device tree is the right
solution and other drivers do similar thing.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla at st.com>
---
.../devicetree/bindings/net/mdio-gpio.txt | 9 ++++++++-
drivers/net/phy/mdio-gpio.c | 11 +++++++----
2 files changed, 15 insertions(+), 5 deletions(-)
diff --git a/Documentation/devicetree/bindings/net/mdio-gpio.txt b/Documentation/devicetree/bindings/net/mdio-gpio.txt
index bc95495..c79bab0 100644
--- a/Documentation/devicetree/bindings/net/mdio-gpio.txt
+++ b/Documentation/devicetree/bindings/net/mdio-gpio.txt
@@ -8,9 +8,16 @@ gpios property as described in section VIII.1 in the following order:
MDC, MDIO.
+Note: Each gpio-mdio bus should have an alias correctly numbered in "aliases"
+node.
+
Example:
-mdio {
+aliases {
+ mdio-gpio0 = <&mdio0>;
+};
+
+mdio0: mdio {
compatible = "virtual,mdio-gpio";
#address-cells = <1>;
#size-cells = <0>;
diff --git a/drivers/net/phy/mdio-gpio.c b/drivers/net/phy/mdio-gpio.c
index 899274f..2ed1140 100644
--- a/drivers/net/phy/mdio-gpio.c
+++ b/drivers/net/phy/mdio-gpio.c
@@ -185,17 +185,20 @@ static int __devinit mdio_gpio_probe(struct platform_device *pdev)
{
struct mdio_gpio_platform_data *pdata;
struct mii_bus *new_bus;
- int ret;
+ int ret, bus_id;
- if (pdev->dev.of_node)
+ if (pdev->dev.of_node) {
pdata = mdio_gpio_of_get_data(pdev);
- else
+ bus_id = of_alias_get_id(pdev->dev.of_node, "mdio-gpio");
+ } else {
pdata = pdev->dev.platform_data;
+ bus_id = pdev->id;
+ }
if (!pdata)
return -ENODEV;
- new_bus = mdio_gpio_bus_init(&pdev->dev, pdata, pdev->id);
+ new_bus = mdio_gpio_bus_init(&pdev->dev, pdata, bus_id);
if (!new_bus)
return -ENODEV;
--
1.7.0.4
More information about the devicetree-discuss
mailing list