[Resend PATCH v3 2/4] ARM: at91: atmel-ssc: add device tree support

Jean-Christophe PLAGNIOL-VILLARD plagnioj at jcrosoft.com
Thu Nov 8 01:30:46 EST 2012


On 14:05 Wed 07 Nov     , Mark Brown wrote:
> On Wed, Nov 07, 2012 at 11:41:21AM +0100, Jean-Christophe PLAGNIOL-VILLARD wrote:
> > On 10:21 Wed 07 Nov     , Mark Brown wrote:
> 
> > > Like I say it's not an issue right now and it seems like it should be
> > > trivial to fix.  Is anything needed here other than adding the
> > > pinctrl_get_set_default() call, in which case would it not be less
> > > effort all round to just send the patch?  If there is more involved then
> > > what is needed?
> 
> > for the driver point of view I agreee with you for the dtsi I disagree I miss
> > 100 lignes of pinctrl description
> 
> > so today if no pinctrl the pin are input gpio and the drivers will not work
> 
> > if this code was tested this work MUST have been done otherwise we will apply
> > non tested work
> 
> > so dor the dtsi part I do NACK it and the pinctrl code is arropund for 2 or 3
> > months so no excuse even Joachim who add the rm9200 support to DT handled the
> > pinctrl so no exeption on at91 when switching to DT the pinctrl is mandatory
> 
> > If you want to apply the part of the patch that touch only the drivers I'm
> > fine but for the dtsi no
> 
> So what the above is saying is that we should have a followup patch to
> add the pinctrl setup to the DT (probably one that goes along with the
> pinctrl changes and adds complete pinctrl setup for the affected boards
> rather than just doing the audio piecemeal) and do the mindless call in
> the driver.  That doesn't seem impossible.
> 
> So long as we get those things in place prior to the merge window we
> should be fine.  Even if we don't manage that it still seems like having
> the patch is better than not having it, from the sounds of it the boards
> are going to be totally broken if they boot with DT but without the
> pinctrl setup and the ASoC bindings are pretty much an orthogonal issue
> to that.  Having the bindings for the SSC (which depend on this AFAICT)
> will allow other machines which are doing a better job with pinctrl to
> work.
so for me Bo re do his patch series by splitting in 2 patch seires

the one via ASoC for the driver with the pinctrl for now but MUST add it later

the arch/arm related via AT91 tree where the pinctrl is mandatory in the dtsi

I'm no going to spend hours to do the pinctrl to test Bo patch that he is
supposed to have deon to test this code

As basically today on DT none of the board will work if BO does no provide the
pinctrl so for me he MUST put in the dtsi

is it ok with you?

Best Regards,
J.


More information about the devicetree-discuss mailing list