Representation of external memory-mapped devices in DT (gpmc)

Rob Herring robherring2 at gmail.com
Thu Nov 1 11:21:57 EST 2012


On 10/31/2012 07:08 PM, Daniel Mack wrote:
> On 30.10.2012 11:50, Afzal Mohammed wrote:
>> Hi Daniel,
>>
>> On Monday 29 October 2012 10:52 PM, Daniel Mack wrote:
>>> On 29.10.2012 16:09, Rob Herring wrote:
>>
>>>> You may want a CS0 node with nand as a child node of that.
>>
>>> Hmm, I don't see what that would buy us. The question is which way is
>>> feasible for storing both the memory region and the cs number in the
>>> device tree. The CS number should certainly go to the child node, no?
>>>
>>> IOW, would it be a good idea to have something like the following layout?
>>>
>>> 	gpmc: gpmc at 50000000 {
>>> 		compatible = "ti,gpmc";
>>> 		ti,hwmods = "gpmc";
>>> 		reg =<0x50000000 0x2000>;
>>>
>>> 		/* cs-reg stores the setup of the controller's
>>> 		   memory map */
>>>
>>> 			/* offset	size */
>>> 		cs-reg =<0x0		0x1000000
>>> 			  ....		.....
>>> 			  ....		.....>;
>>>
>>> 		nand: child at 0 {
>>> 			/* timings */
>>> 			/* peripheral specifics */
>>> 		};
>>> 	};
>>>
>>> I would actually much prefer that approach.
>>>
>>> Afzal, because because that way, we can leave the code as-is for now and
>>> add the "cs-reg" property once the code is switched to dynamic handling.
>>> What do you think?
>>
>> I don't know what to say, don't have a good grasp on DT to give
>> right suggestion.
>>
>> It seems offset field may not be necessary. memory for connected
>> peripherals is not fixed, only CS is fixed (as CS pin is hard-wired).
>> Physical memory can be anywhere between 0-512MB (with
>> alignment constraints depending on size, refer GPMC_CONFIG7
>> register), even though right now memory region for peripheral
>> seems to be fixed (for boards supported in mainline it will be
>> what bootloader configures), it is possible to have it in a different
>> region for those peripherals.
> 
> The question is whether this is transparent to the client driver at the
> end. If the driver needs to know about the address of the external
> memory (that's the case for the smsx911x for example), that value should
> be in the device tree.
> 
> Actually, there's an example here that matches our case quite well:
> 
> http://devicetree.org/Device_Tree_Usage#Ranges_.28Address_Translation.29
> 

I had tried to find an example in PPC dts files, but didn't. This
example is what you should follow.

> I think the important part is to get the bindings straight so we don't
> have to change them anymore later on; we don't really need to parse the
> values from the generic driver and set up the mappings accrodingly -
> that can be added easily later on. For a first shot, we can just write
> default values to the DT that are computed anyway, right?

For whatever parts of a CS are programmable, make sure they are in the
DT or you can calculate them from the DT data.

Rob



More information about the devicetree-discuss mailing list