[PATCH v2 4/4] arm/dts: OMAP3: Add mmc controller nodes and board data

[Grant Likely]

On Fri, 24 Feb 2012 10:49:00 -0800, Tony Lindgren <tony at atomide.com> wrote:
> * Rajendra Nayak <rnayak at ti.com> [120223 19:29]:
> > On Friday 24 February 2012 12:27 AM, Tony Lindgren wrote:
> > >>--- a/arch/arm/boot/dts/omap3.dtsi
> > >>+++ b/arch/arm/boot/dts/omap3.dtsi
> > >>@@ -113,5 +113,31 @@
> > >>  			#size-cells =<0>;
> > >>  			ti,hwmods = "i2c3";
> > >>  		};
> > >>+
> > >>+		mmc1: mmc at 1 {
> > >>+			compatible = "ti,omap2-hsmmc";
> > >>+			ti,hwmods = "mmc1";
> > >>+			ti,dual-volt;
> > >>+		};
> > >>+
> > >>+		mmc2: mmc at 2 {
> > >>+			compatible = "ti,omap2-hsmmc";
> > >>+			ti,hwmods = "mmc2";
> > >>+		};
> > >>+
> > >>+		mmc3: mmc at 3 {
> > >>+			compatible = "ti,omap2-hsmmc";
> > >>+			ti,hwmods = "mmc3";
> > >>+		};
> > >>+
> > >>+		mmc4: mmc at 4 {
> > >>+			compatible = "ti,omap2-hsmmc";
> > >>+			ti,hwmods = "mmc4";
> > >>+		};
> > >>+
> > >>+		mmc5: mmc at 5 {
> > >>+			compatible = "ti,omap2-hsmmc";
> > >>+			ti,hwmods = "mmc5";
> > >>+		};
> > >>  	};
> > >>  };
> > >
> > >These all should all be "ti,omap3-hsmmc" I guess?
> > 
> > Well, I defined the binding such that both omap2 and omap3
> > can use the same compatible "ti,omap2-hsmmc" since there is
> > no difference in the way they are defined or handled. If thats
> > confusing, I can have separate compatibles.
> > Btw, I guess we do the same with a few other re-used IPs as well,
> > I just checked and mcpsi does the same.
> 
> Yeah let's use separate compatibles to avoid confusion.
> For omap2 we also have the ti,omap2-mmc in addition to
> ti,omap2-hsmmc..

Yes, absolutely use separate compatible values.  It is always important
to be specific as to the silicon implementing the IP.  The omap3 instance
can also carry the omap2 string in its compatible list:

	compatible = "ti,omap3-hsmmc", "ti,omap2-hsmmc";

g.