Sharing PCIE driver between Microblaze and Arm zynq

Michal Simek monstr at monstr.eu
Mon Dec 10 18:36:40 EST 2012


2012/12/7 Arnd Bergmann <arnd at arndb.de>:
> On Friday 07 December 2012, Michal Simek wrote:
>> On 12/06/2012 10:27 PM, Bjorn Helgaas wrote:
>> > [+cc linux-pci]
>> >
>> > On Thu, Dec 6, 2012 at 7:23 AM, Michal Simek <michal.simek at xilinx.com> wrote:
>> >> Hi guys,
>> >>
>> >> I have a question regarding to sharing generic OF pcie driver between
>> >> two architectures MB and ARM Zynq.
>> >> Is drivers/pci/pcie location good for it?
>> >> Make no sense to have the same driver in two locations.
>> >
>> > I think you're talking about a PCI host bridge driver.  It would
>> > definitely be nice to move toward a generic, shared driver.  Host
>> > bridge drivers are responsible for enumerating the PCI hierarchy below
>> > the bridge.  Enumeration is not really PCIe-specific, so I wouldn't
>> > put it in drivers/pci/pcie.
>>
>> Not a PCI expert, just trying to find out the proper location for this shared driver.
>
> I'd suggest creating a drivers/pci/host directory. We will have more of
> these in the future. AFAIK, there is no fully generic (architecture
> independent) way to interface a PCI host driver to the PCI subsystem,
> but I think we are getting closer to that. You are probably fairly
> free to modify the microblaze architecture specific code though if needed.

yep.


>> >> Is using readl/writel IO functions in this driver the best option
>> >> which we can have?
>> >> Or is there any other recommendation?
>> >
>> > I'm not really a driver person, but if you're writing a new driver,
>> > wouldn't you use the iomap interfaces (ioremap(), ioread32(), etc)
>> > rather than readl()?
>>
>> That driver exists but it is not in mainline and it is better to directly
>> add it to proper location with correct io functions.
>> The question is if ioread/iowrite functions are correct one.
>> PowerPC io-defs.h suggests that readl/writel should be used for PCI.
>
> ioread32/iowrite32 are defined to behave the same way readl/writel regarding
> addressing modes and barriers, but also allow operating on __iomem pointers
> that were returned from ioport_map(). You probably don't need that.
>
> Some architectures like powerpc have their own accessors for on-chip MMIO
> areas, but ARM does not. The PowerPC rule is that you must use either
> readl/writel or ioread32/iowrite32 to access devices connected to a PCI
> bus, but you would not necessarily do that for the PCI host controller
> itself on PowerPC.

ok.

Thanks,
Michal


-- 
Michal Simek, Ing. (M.Eng)
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel 2.6 Microblaze Linux - http://www.monstr.eu/fdt/
Microblaze U-BOOT custodian


More information about the devicetree-discuss mailing list