[PATCH V5 2/2] mfd: stmpe: Update DT support in stmpe driver

[Lee Jones]

> > But regardless, it is the responsiblity of the probe function to go and
> > look if of_driver_match_device() matches against anything if it cares
> > about the of_match_table entries (for instance, if there is extra data
> > attached).
> 
> Ok, so filling .data field in of_device_id[] is not required for our case as
> we aren't doing anything special in our drivers.

This is exactly my point, and the reason I bought it up in the
first place. Normally when you specify an ID table and populate
the .data attribute, you parse for it in the code and then cast
it back to some kind of useful data. However, you're not doing
that, which is precisely why I wondered if the table was
necessary at all. In all my testing, the DT portion worked and
the correct STMPE chip was identified without it.

So, are you adding the table for good reason, or because you
think it's the right thing to do?

-- 
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog