[PATCH 5/5] arm/dt: tegra: Fix SDHCI nodes to match board files

[Jean-Christophe PLAGNIOL-VILLARD]

On 08:12 Tue 22 Nov     , Stephen Warren wrote:
> Jean-Christophe PLAGNIOL-VILLARD wrote at Tuesday, November 22, 2011 1:38 AM:
> > On 14:44 Mon 21 Nov     , Stephen Warren wrote:
> > > Mark any SDHCI controllers that aren't registered by the board files as
> > > disabled in the device-tree files.
> > >
> > > In practice, these controllers:
> > >
> > > * Have nothing hooked up to them at all, or
> > > * For ports intended for SDIO usage, the drivers for anything that might
> > >   be attached are not in the device-tree yet. If/when drivers appear, the
> > >   SD/MMC port can be re-enabled.
> > >
> > > The only possible exception is TrimSlice's mico SD slot, but that wasn't
> > > enabled in the board files before anyway, and doesn't work when all the
> > > SDHCI controllers are enabled anyway.
> > it will be better to invert the logic
> > 
> > just enable what you are supposed too
> 
> It used to be that way when the files were first added, but they got
> switched around this way to match standard practice.
this is a bad practice because you can enable stuff that a hardware is not
supposed to use

and this silenty without anyone notice until you test the hardware

and you add more line and changeset

Best Regrds,
J.