[PATCH 1/1] net/macb: add DT support
Jamie Iles
jamie at jamieiles.com
Sat Nov 19 02:58:24 EST 2011
Hi Jean-Christophe,
On Fri, Nov 18, 2011 at 03:29:25PM +0100, Jean-Christophe PLAGNIOL-VILLARD wrote:
> allow the DT to pass the mac address and the phy mode
>
> Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
> Cc: Jamie Iles <jamie at jamieiles.com>
> Cc: Nicolas Ferre <nicolas.ferre at atmel.com>
This looks OK to me in principle. I can't easily test this at the
moment, but as I don't have a DT platform that has the clk framework up
and running. A couple of nits/questions inline, but thanks for doing
this!
Jamie
> ---
> Documentation/devicetree/bindings/net/macb.txt | 22 ++++++++
> drivers/net/ethernet/cadence/macb.c | 65 +++++++++++++++++++++---
> drivers/net/ethernet/cadence/macb.h | 2 +
> 3 files changed, 81 insertions(+), 8 deletions(-)
> create mode 100644 Documentation/devicetree/bindings/net/macb.txt
>
> diff --git a/Documentation/devicetree/bindings/net/macb.txt b/Documentation/devicetree/bindings/net/macb.txt
> new file mode 100644
> index 0000000..2b727ec
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/macb.txt
> @@ -0,0 +1,22 @@
> +* Cadence EMACB
> +
> +Implemeted on Atmel AT91 & AVR32 SoC
I think something along the lines of "Binding for the Cadence MACB
Ethernet controller" rather than listing specific parts might be
clearer.
> +
> +Required properties:
> +- compatible : Should be "atmel,macb" for Atmel
> +- reg : Address and length of the register set for the device
> +- interrupts : Should contain macb interrupt
> +- phy-mode : String, operation mode of the PHY interface.
> + Supported values are: "mii", "rmii",
> +
> +Optional properties:
> +- local-mac-address : 6 bytes, mac address
> +
> +Examples:
> +
> + macb0: macb at fffc4000 {
Rob pointed out to me a little while ago that the preferred naming from
the ePAPR document would be:
macb0: ethernet at fffc4000
so it might be worth being consistent here.
> + compatible = "atmel,macb";
This should be "cdns,macb" as it isn't Atmel specific. I believe cdns
is the correct stock ticker symbol for Cadence.
> + reg = <oxfffc4000 0x4000>;
> + interrupts = <21>;
> + phy-mode = "mii";
> + };
> diff --git a/drivers/net/ethernet/cadence/macb.c b/drivers/net/ethernet/cadence/macb.c
> index a437b46..2c345bc 100644
> --- a/drivers/net/ethernet/cadence/macb.c
> +++ b/drivers/net/ethernet/cadence/macb.c
> @@ -20,6 +20,9 @@
> #include <linux/etherdevice.h>
> #include <linux/dma-mapping.h>
> #include <linux/platform_device.h>
> +#include <linux/of.h>
> +#include <linux/of_device.h>
> +#include <linux/of_net.h>
> #include <linux/phy.h>
>
> #include <mach/board.h>
> @@ -81,6 +84,20 @@ static void __init macb_get_hwaddr(struct macb *bp)
> addr[4] = top & 0xff;
> addr[5] = (top >> 8) & 0xff;
>
> +#ifdef CONFIG_OF
> + /*
> + * 2) from device tree data
> + */
> + if (!is_valid_ether_addr(addr)) {
> + struct device_node *np = bp->pdev->dev.of_node;
> + if (np) {
> + const char *mac = of_get_mac_address(np);
> + if (mac)
> + memcpy(addr, mac, sizeof(addr));
> + }
> + }
> +#endif
I'm a bit conflicted here. I think we should always use the MAC address
from the device tree if it is present even if the current MAC address is
valid.
> +
> if (is_valid_ether_addr(addr)) {
> memcpy(bp->dev->dev_addr, addr, sizeof(addr));
> } else {
> @@ -191,7 +208,6 @@ static int macb_mii_probe(struct net_device *dev)
> {
> struct macb *bp = netdev_priv(dev);
> struct phy_device *phydev;
> - struct eth_platform_data *pdata;
> int ret;
>
> phydev = phy_find_first(bp->mii_bus);
> @@ -200,14 +216,11 @@ static int macb_mii_probe(struct net_device *dev)
> return -1;
> }
>
> - pdata = bp->pdev->dev.platform_data;
> /* TODO : add pin_irq */
>
> /* attach the mac to the phy */
> ret = phy_connect_direct(dev, phydev, &macb_handle_link_change, 0,
> - pdata && pdata->is_rmii ?
> - PHY_INTERFACE_MODE_RMII :
> - PHY_INTERFACE_MODE_MII);
> + bp->phy_interface);
> if (ret) {
> printk(KERN_ERR "%s: Could not attach to PHY\n", dev->name);
> return ret;
> @@ -1117,6 +1130,30 @@ static const struct net_device_ops macb_netdev_ops = {
> #endif
> };
>
> +#if defined(CONFIG_OF)
> +static const struct of_device_id macb_dt_ids[] = {
> + { .compatible = "atmel,macb" },
cdns,macb again.
> + { /* sentinel */ }
> +};
> +
> +MODULE_DEVICE_TABLE(of, macb_dt_ids);
> +
> +static int __devinit macb_get_phy_mode_dt(struct platform_device *pdev)
> +{
> + struct device_node *np = pdev->dev.of_node;
> +
> + if (np)
> + return of_get_phy_mode(np);
> +
> + return -ENODEV;
> +}
> +#else
> +static int __devinit macb_get_phy_mode_dt(struct platform_device *pdev)
> +{
> + return -ENODEV;
> +}
> +#endif
> +
> static int __init macb_probe(struct platform_device *pdev)
> {
> struct eth_platform_data *pdata;
> @@ -1210,20 +1247,31 @@ static int __init macb_probe(struct platform_device *pdev)
> macb_writel(bp, NCFGR, config);
>
> macb_get_hwaddr(bp);
> - pdata = pdev->dev.platform_data;
>
> - if (pdata && pdata->is_rmii)
> + err = macb_get_phy_mode_dt(pdev);
> + if (err < 0) {
> + pdata = pdev->dev.platform_data;
> + if (pdata && pdata->is_rmii)
> + bp->phy_interface = PHY_INTERFACE_MODE_RMII;
> + else
> + bp->phy_interface = PHY_INTERFACE_MODE_MII;
> + } else {
> + bp->phy_interface = err;
> + }
> +
> + if (bp->phy_interface == PHY_INTERFACE_MODE_RMII) {
> #if defined(CONFIG_ARCH_AT91)
> macb_writel(bp, USRIO, (MACB_BIT(RMII) | MACB_BIT(CLKEN)) );
> #else
> macb_writel(bp, USRIO, 0);
> #endif
> - else
> + } else {
> #if defined(CONFIG_ARCH_AT91)
> macb_writel(bp, USRIO, MACB_BIT(CLKEN));
> #else
> macb_writel(bp, USRIO, MACB_BIT(MII));
> #endif
> + }
>
> bp->tx_pending = DEF_TX_RING_PENDING;
>
> @@ -1344,6 +1392,7 @@ static struct platform_driver macb_driver = {
> .driver = {
> .name = "macb",
> .owner = THIS_MODULE,
> + .of_match_table = of_match_ptr(macb_dt_ids),
> },
> };
>
> diff --git a/drivers/net/ethernet/cadence/macb.h b/drivers/net/ethernet/cadence/macb.h
> index d3212f6..8342744 100644
> --- a/drivers/net/ethernet/cadence/macb.h
> +++ b/drivers/net/ethernet/cadence/macb.h
> @@ -389,6 +389,8 @@ struct macb {
> unsigned int link;
> unsigned int speed;
> unsigned int duplex;
> +
> + phy_interface_t phy_interface;
> };
>
> #endif /* _MACB_H */
> --
> 1.7.7
>
More information about the devicetree-discuss
mailing list