[PATCH 5/6] mmc: Add OF bindings support for mmc host controller capabilities

[Thomas Abraham]

On 5 November 2011 01:27, Olof Johansson <olof at lixom.net> wrote:
> On Thu, Nov 03, 2011 at 02:06:02AM +0530, Thomas Abraham wrote:
>> Device nodes representing sd/mmc controllers in a device tree would include
>> mmc host controller capabilities. Add support for parsing of mmc host
>> controller capabilities included in device nodes.
>>
>> Signed-off-by: Thomas Abraham <thomas.abraham at linaro.org>
>> ---
>>  .../devicetree/bindings/mmc/linux-mmc-host.txt     |   13 ++++++++
>>  drivers/mmc/core/host.c                            |   31 ++++++++++++++++++++
>>  include/linux/mmc/host.h                           |    1 +
>>  3 files changed, 45 insertions(+), 0 deletions(-)
>>  create mode 100644 Documentation/devicetree/bindings/mmc/linux-mmc-host.txt
>>
>> diff --git a/Documentation/devicetree/bindings/mmc/linux-mmc-host.txt b/Documentation/devicetree/bindings/mmc/linux-mmc-host.txt
>> new file mode 100644
>> index 0000000..714b2b1
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/mmc/linux-mmc-host.txt
>> @@ -0,0 +1,13 @@
>> +* Linux MMC Host Controller Capabilities
>> +
>> +The following bindings can be used in a device node to specify any board
>> +specific mmc host controller capabilities.
>> +
>> +- linux,mmc_cap_4_bit_data - Host can do 4-bit transfers
>> +- linux,mmc_cap_mmc_highspeed - Host can do MMC high-speed timing
>> +- linux,mmc_cap_sd_highspeed - Host can do SD high-speed timing
>> +- linux,mmc_cap_needs_poll - Host needs polling for card detection
>> +- linux,mmc_cap_8_bit_data - Host can do 8-bit transfer
>> +- linux,mmc_cap_disable - Host can be disabled and re-enabled to save power
>> +- linux,mmc_cap_nonremovable - Host is connected to nonremovable media
>> +- linux,mmc_cap_erase - Host allows erase/trim commands
>
> linux-prefixed properties are a big red flag. The device tree should describe
> the hardware, not what linux does with the hardware.

The vendor-prefixes documentation for device tree bindings includes
'linux' as an option. And I was trying to encode the linux specific
host controller capabilities using the above bindings.

>
> See previous comments about "support-8bit" for encoding exactly the same
> hardware capability in a linux-agnostic way. What the sdhci driver chooses to
> do with it is up to the driver, and in some cases it means it will set the
> capabilities flag.
>
> Same goes for the other properties. It should not go in as it is
> implemented in this patch, it needs to be fixed up.

Ok. I will remove all these linux specific bindings and replace with a
more generic ones. Bindings will be defined for all the linux defined
host capabilities. Non-linux platforms can add additional bindings as
required. A function to parse such properties from a controller device
node could actually be shared among all the mmc/sd host controller
drivers in linux. I will redo this patch and submit again.

Thanks Olof for your review and comments.

Regards,
Thomas.

>
>
> -Olof
>