[PATCH v3 2/3] ARM: mxc: use ARCH_NR_GPIOS to define gpio number

Grant Likely grant.likely at secretlab.ca
Fri Jul 8 05:24:29 EST 2011


On Thu, Jul 07, 2011 at 09:47:55AM +0200, Sascha Hauer wrote:
> On Thu, Jul 07, 2011 at 12:37:42AM +0800, Shawn Guo wrote:
> > The patch removes MXC_GPIO_IRQS and instead uses ARCH_NR_GPIOS to
> > define gpio number.  This change is need when we change mxc gpio
> > driver to be device tree aware.  When migrating the driver to device
> > tree, pdev->id becomes unusable.  It requires driver get gpio range
> > from gpio core, which will dynamically allocates number from
> > ARCH_NR_GPIOS to 0.
> > 
> > As a bonus point, it removes lines of '#if' and make the code a
> > little bit cleaner.  The side effect is the waste of number.  But
> > this is not a point when we go single image.
> 
> I'm not sure whether we really should depend on an externally defined
> ARCH_NR_GPIOS. Someone might get the idea to change this to a lower
> value. Maybe we should define this ourselves instead.
> 
> Any other opinions?
> 
> Otherwise I'm fine with this patch.

/me would like to be rid of ARCH_NR_GPIOS entirely, but we're a long
way away from that.

g.

> 
> Sascha
> 
> > 
> > Signed-off-by: Shawn Guo <shawn.guo at linaro.org>
> > Cc: Sascha Hauer <s.hauer at pengutronix.de>
> > Cc: Grant Likely <grant.likely at secretlab.ca>
> > ---
> >  arch/arm/plat-mxc/include/mach/irqs.h |   21 +++------------------
> >  1 files changed, 3 insertions(+), 18 deletions(-)
> > 
> > diff --git a/arch/arm/plat-mxc/include/mach/irqs.h b/arch/arm/plat-mxc/include/mach/irqs.h
> > index 35c89bc..00e812b 100644
> > --- a/arch/arm/plat-mxc/include/mach/irqs.h
> > +++ b/arch/arm/plat-mxc/include/mach/irqs.h
> > @@ -11,6 +11,8 @@
> >  #ifndef __ASM_ARCH_MXC_IRQS_H__
> >  #define __ASM_ARCH_MXC_IRQS_H__
> >  
> > +#include <asm-generic/gpio.h>
> > +
> >  /*
> >   * SoCs with TZIC interrupt controller have 128 IRQs, those with AVIC have 64
> >   */
> > @@ -22,30 +24,13 @@
> >  
> >  #define MXC_GPIO_IRQ_START	MXC_INTERNAL_IRQS
> >  
> > -/* these are ordered by size to support multi-SoC kernels */
> > -#if defined CONFIG_SOC_IMX53
> > -#define MXC_GPIO_IRQS		(32 * 7)
> > -#elif defined CONFIG_ARCH_MX2
> > -#define MXC_GPIO_IRQS		(32 * 6)
> > -#elif defined CONFIG_SOC_IMX50
> > -#define MXC_GPIO_IRQS		(32 * 6)
> > -#elif defined CONFIG_ARCH_MX1
> > -#define MXC_GPIO_IRQS		(32 * 4)
> > -#elif defined CONFIG_ARCH_MX25
> > -#define MXC_GPIO_IRQS		(32 * 4)
> > -#elif defined CONFIG_SOC_IMX51
> > -#define MXC_GPIO_IRQS		(32 * 4)
> > -#elif defined CONFIG_ARCH_MX3
> > -#define MXC_GPIO_IRQS		(32 * 3)
> > -#endif
> > -
> >  /*
> >   * The next 16 interrupts are for board specific purposes.  Since
> >   * the kernel can only run on one machine at a time, we can re-use
> >   * these.  If you need more, increase MXC_BOARD_IRQS, but keep it
> >   * within sensible limits.
> >   */
> > -#define MXC_BOARD_IRQ_START	(MXC_INTERNAL_IRQS + MXC_GPIO_IRQS)
> > +#define MXC_BOARD_IRQ_START	(MXC_INTERNAL_IRQS + ARCH_NR_GPIOS)
> >  
> >  #ifdef CONFIG_MACH_MX31ADS_WM1133_EV1
> >  #define MXC_BOARD_IRQS  80
> > -- 
> > 1.7.4.1
> > 
> > 
> > 
> 
> -- 
> Pengutronix e.K.                           |                             |
> Industrial Linux Solutions                 | http://www.pengutronix.de/  |
> Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
> Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |
> 
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel


More information about the devicetree-discuss mailing list